rv

The screen door may be separated from the main entry door by depressing the catch or releasing the magnet. A holdback mechanism can be used to secure the main door against the side of the motor home. Before leaving a camp site, please control all drawers, cupboard and other doors inside the car and have them locked. Also lock the cabin's outside doors. Check for loose items, (e.g. drawers or doors which cannot be locked) and if necessary have them fixed with a tape. Walk again around the vehicle, look whether the door steps are in an upright and safe position and nothing left at the site. Have a look under the car too.

up

The dividers allow you to separate areas in the motor home. They glide on nylon rollers and do not require lubrication. They are held closed by a catch. When the dividers are open for traveling, be sure to attach the hold back straps to keep them from sliding back and forth.

Manual Entry Steps (some models):
Entry steps are located under the rear entry door. 

To extend the manual step:
Pull step assembly out; let it down completely. Push step all the way in to store.

Power entry Steps:
The power entry step is controlled by the ignition switch and by switches on the instrument panel and near the entry step. Power for the entry step is supplied by the coach battery. The battery must be connected for the step to operate as described below. The switches operate the step according to the following table.

up

OFF ON Step extends and re tracts with the opening and closing of the door

OFF OFF Step is inactive and will not move regard less of door movement

ON ON Step extends and re tracts with opening and closing of door

ON OFF Step is retracted for all door positions. If step is extended when ignition is turned ON, step will retract

up