RV CENTRAL

Site Directory Leaseback Program References Rental Rates Contact Us
Home
Site Directory
Rental Rates
Make Money
Reservations
References
List of Charges
Breakdown of Fees
Insurance
One Way Trips
Questions
Tow-behind Vehicles
Housekeeping Kits
Specials
Las Vegas
Raceway Deal
Mexico
Corporate Clients
Dump Sites
Airport Shuttle
Traveler Help
Pets
Driving an RV
Contact Us
RV Classes
Your RV
Campgrounds
Glossary of Terms
RV History

 

 

 

 

Overhead Vents
Camper Affitto alquilar autocaravanas camping cars Las Vegas RV rentals LAS

Close the vents before traveling to avoid damage from wind and low overhead clearances.
return to Rental Rates page
Caravan / RV Manual page
motorises maisons motorisees Reisemobilvermietung zwerfautos motorhome RVs

Overhead vents are located in the galley and bathroom areas for fresh air circulation and exhausting heat, odors and water vapor. Roof vents include the crank-up vent/skylight, refrigerator vent, and plumbing vents. Most crank-ups fit into or over a 14" square opening this is the "nominal" size, the actual vent sizes vary slightly but are approximately 15 /12" square on the outside.

Turn the crank in the center of the vent to open and adjust. Some vents may also be equipped with a 12-volt fan. A switch controls fan operation. Be sure to turn the fan OFF before closing the vent.

Close the vents or lower them before traveling to avoid damage from wind and low overhead clearances.

The vent may be cleaned from the top of the motor home. Use soapy water on the vent cover. The screens may be vacuumed or lightly brushed to remove accumulation of leaves or other debris.

Lubricate the gears and mechanism yearly with a light, water resistant grease.

The condition of roof vent covers should be checked annually, covers that have a dull lifeless look should be replaced, when this point is reached they are generally quite brittle. A cover in good condition usually has a shiny appearance.

Plastic framed roof vents should be inspected carefully for cracks in the frame, both on the roof and from inside, with the inside trim ring removed. If any cracks are observed the vent should be replaced.